Torc Ground Anchor Series II - Fitting Kit Contents

Concrete Floor Fitting Kit

The Torc anchor floor fitting kit uses top quality resin capsules for maximum security in variable condition concrete floors:

• M10 x 90mm long high tensile (10.9-rated) hex socket countersunk bolts, fully threaded (qty. 4)
• M10 chemical resin anchor capsules (qty. 4) (photo shows a single capsule, with the internal vial of hardener visible in white)
• Hardened steel ball bearings to suit bolts (qty. 4)
• Hex driver bit 6mm AF to suit bolts
• M8 x 50mm hex head bolt (to help with hammering the ball bearings into the bolt heads)

• Length of flexible PVC hose (to help clean the holes)
• Masonry hammer drill bit 12mm straight shank (SDS-Plus optional at extra cost)
• Comprehensive instructions

Injection Resin Fitting Kit - 100ml and 150ml Options

The Torc anchor Injection Resin fitting kits use top quality vinylester resin for maximum security in variable condition concrete, brick, block and other substrates including with modest voids/air spaces:

• M10 x 90mm long high tensile (10.9-rated) hex socket countersunk bolts, fully threaded (qty. 4)
• 100ml Kit: Fischer FIS-VS-100P Vinylester resin cartridge with mixer nozzle and screw plunger (or equivalent) (shown in photo here)
• 150ml Kit: Fischer FIS-VS-150C Vinylester resin cartridge with mixer nozzle (or equivalent) Note: Strong skeleton gun required to use this cartridge!
  

• Hardened steel ball bearings to suit bolts (qty. 4)
• Hex driver bit 6mm AF to suit bolts
• M8 x 50mm hex head bolt (to help with hammering the ball bearings into the bolt heads)
• Length of flexible PVC hose (to help clean the holes)
• Masonry hammer drill bit 12mm straight shank (SDS-Plus optional at extra cost)
• Comprehensive instructions

Brick Wall Fitting Kit

The Torc Ground Anchor should not be fitted to a block wall, or to a brick wall within 2.0 metres (6 feet) of its top edge - do not fit it to a low garden wall! Similarly, you should choose a location that is at least 0.3 metres (1 foot) from the nearest end of the wall - don't fit it close to an external corner. If the wall can be knocked over you have no security!

• M10 x 70mm long high tensile (10.9-rated) hex socket countersunk bolts, fully threaded (qty. 4)
• M10 shield anchors (qty. 4)
• Hardened steel ball bearings to suit bolts (qty. 4)
• 6mm hex wrench (Allen key)
• Hex driver bit 6mm AF to suit bolts
• M8 x 50mm hex head bolt (to help with hammering the ball bearings into the bolt heads)
• Length of flexible PVC hose (to help clean the holes)
• Masonry hammer drill bit 16mm straight shank (SDS-Plus shank optional at extra cost)
• Comprehensive instructions

Van/Bike Safe Fitting Kit

The Torc anchor van fitting kit is designed for easy installation in a van or other thin-walled metal enclosure (including bike safes):

• M10 x 40mm long high tensile (10.9-rated) hex socket countersunk bolts, fully threaded (qty. 4)
• M10 security shear nuts (qty. 4)
• M10 penny washers (qty. 4)
• Hardened steel ball bearings to suit bolts (qty. 4)
• 6mm hex wrench (Allen key)
• M8 x 50mm hex head bolt (to help with hammering the ball bearings into the bolt heads)
• Comprehensive instructions